- Proteins and Peptides
- Lysates and Cell Lines
Protocol specific for Monoamine Oxidase A Antibody (NBP1-19796) Immunohistochemistry (formalin fixed paraffin-embedded sections)
1.1. Heat slides in an oven at 65 degrees C for 1 hour.
1.2. De-paraffinize/hydrate using the following series of washes: two Xylene washes (3 min each), followed by two 100% ethanol rinses (3 min each), followed by 95% ethanol, 70% ethanol, 50% ethanol, 30% ethanol, followed by TBST wash for 3 min on a shaker.
II. Antigen Retrieval
This is recommended Heat Induced Epitope Retrieval (HIER) using Decloaking Chamber/Pressure Cooker. Hot water bath or Microwave with temperature sensor can be also used (protocol would vary depending on the method used).
2.1. Add 500 ml of dH 2O to Decloaker/Pressure Cooker.
2.2. Immerse slides into staining dish containing Antigen Retrieval Solution. Place staining dish into decloaking chamber.
2.3. Program to run for 30 seconds at 125 degrees C, followed by 10 seconds at 90 degrees C.
2.4. Let it cool down to room temperature (10 - 20 minutes).
2.5. Removes slides and rinse in TBST.
2.6. Proceed to Staining step.
3.1. Wash slides with TBST for 3 min on a shaker.
3.2. Inactivate endogenous peroxidase by covering tissue with 3% hydrogen peroxide for 5 min.
3.3. Wash slides three times with TBST (3 min each on a shaker).
3.4. Block slides with the blocking solution for 1 hour.
3.5. Dilute NBP1-19796 1:50-1:200.
3.6. Apply NBP1-19796 to each section and incubate overnight in the humidified chamber (4 degrees C).
3.7. Wash slides three times with TBST (3 min each on a shaker).
3.8. Apply to each section secondary HRP-conjugated anti-rabbit antibody diluted in the blocking solution per manufacturer's recommendation; incubate for 30 min at room temperature.
3.9. Wash slides three times with TBST (5 min each on a shaker).
3.10. Add freshly prepared DAB substrate to the sections and incubate until stain develops (generally 1 min).
3.11. Rinse sections with water.
3.12. Counterstain with Hematoxylin (generally 10 seconds).
3.13. Rinse sections with water.
3.14. Dehydrate samples using two washes with 100% Ethanol (3 min each), followed by two rinses with Xylene (3 min each).
3.15. Mount coverslips on slides using permanent mounting medium.